Switchingbetweentwo channels
usingChannelReturn
The Channel Return feature allows you to switch
between two channels without entering an actual
channel number each time. This feature also works for
external inputs.
1 Select the first channel you want to view.
2 Select a second channel using the Channel Number
buttons (and the dash ((_) button if needed).
13 Press @ on the remote control. The previous
channel will display. Each time you press @, the
TV will switch back and forth between the last two
channels that were tuned.
Switchingbetweentwo channels
usingSurfLockTM
The SurfLock '_' feature temporarily "memorizes" one
channel to the @ button, so you can return to that
channel quickly from any other channel with @. This
feature also works for external inputs.
To memorize a channel to the _T_button:
1
2
3
Tune the channel you want to program into the @
button.
Press and hold @ for about 2 seconds until the
message "Memorized" appears. The channel has
been programmed to the ,_ button.
You can then change channels repeatedly, and
when you press @, the memorized channel will be
tuned.
The TV will return to the memorized channel one time
only. Once you press and then change channels
again, the memory will be cleared and the button will
function as Channel Return.
Selecting the video input to view
To select the video input to view:
1
2
Press _) on the remote control or TV control panel.
And then either:
* Press 0-6; or
* Repeatedly press • or V, then press _2_to change
the input; or
* Repeatedly press _) to change the input.
Q ANT/CABLE
Note:
• You can label the video input sources according to the
specific devices you have connected to the TV
(_,_ "Labeling video input sources" on page 36).
° Sources can also be skipped (_,_ "Setting video input
skip" on page 36).
° Inputs that are set to skip will be grayed out and will be
skipped over when selecting inputs by repeatedly
pressing _) or • or V. They are only available by using
direct number entry.
° If one or more REGZA-LINK ® devices are connected to
an HDMI input, the REGZA-LINK ®icon will appear in the
input selector. In this case, the label (_ page 36) will not
appear in the input selector.
To select a REGZA-LINK _ device:
1 Press • or • to highlight an appropriate HDMI
input.
Press • to display the list of REGZA-LINK ® devices
for that input.
13 If there are multiple REGZA-LINK ® devices on the
input, use • or • to highlight a particular device.
4 Press @ to select the device and change inputs.
41
To Next Page
Loading...
Need help?
General
Weight and Dimensions
