RT-SVP04F-EN 51
System Operating Status
GBAS 0-5 VDC Module Relay Output Status
Output 1 OFF
Used With: All Units when GBAS 0-
5 VDC is installed
1. Press the NEXT key to display GBAS 0-5 VDC Outputs 2, 3, 4 and 5. Possible Values: ON, OFF
2. Press the NEXT key until the following screen is displayed.
End of Submenu (Next) to enter Status
1. Press the NEXT key to leave the submenu and show following
screen.
2. Press PREVIOUS to page back through the submenu.
GBAS 0-10 VDC Module STATUS submenu screens
GBAS 0 - 10 VDC Module Status Submenu
Press ENTER to View Data in This Submenu
Used With: All Units when GBAS 0-
10 VDC is installed
1. Press the NEXT key to bypass this menu and advanced to "General
Status" Display screen.
GBAS 0-10 VDC Module Analog Input 0.00 VDC
Assigned: NOT ASSIGNED
Used With: With GBAS 0-10 VDC
Module
Possible Values: Input = 0.00 to
10.0 VDC
Assigned: NOT ASSIGNED, Unocc
Zone Cooling SETPOINT, Occ Zone
Heating SETPOINT, Unocc Zone
Heating SETPOINT, Supply Air
Cooling SETPOINT, Supply Air
heating SETPOINT, Space Pressure
SETPOINT, SA Pressure SETPOINT,
Min OA Flow SETPOINT, MWU
SETPOINT, Econ Dry Bulb Enable
SETPOINT, Minimum Enable
SETPOINT, Occ Dehumidification
Setpoint, Unocc Dehumidification
Setpoint, Supply Air Reheat
Setpoint, Occ Humidification
SETPOINT, Unocc Humidification
SETPOINT
1. Press the NEXT key to display Generic BAS Analog Input screens 2, 3
& 4.
2. Press the NEXT key to advance to the following
GBAS 0-10 VDC Demand Limit Input Status
Open
Used With: With GBAS 0-10 VDC
Module
Possible Values: Open, Closed
1. Press the NEXT key until the following screen is displayed.
GBAS 0-10 VDC Binary Output OFF
Assigned: OUTPUT IS NOT ASSIGNED
Used With: With GBAS 0-10 VDC
Module
Possible Values: Output= ON, OFF
Output is not assigned, Indicate
selected diag alarms*, Any Active
Diagnostic
Note: *See Alarm Listing under
RTM Alarm Output
To Next Page
Loading...
Need help?
General
