Privacy/security 139
Privacy/security
Activating and deactivating the ringer
Activating and deactivating the ringer permanently or
setting to beep
If you do not want to be disturbed by the phone ringing for an incoming call, you
can deactivate the ringer permanently or set it so that you are only advised of a
call by a beep every 25 seconds. You can also configure the settings while the
phone is ringing.
) Hold down the key (approx. 2 seconds) until the "Ringer off" icon appears on the
status bar on the display (
ïƒ Page 24).
The ringtone is deactivated.
) To switch the function off again, hold down the key until the "Ringer off" icon
disappears from the status bar on the display.
You can also switch the function on and off using the option in the idle menu.
Select and confirm the option shown.
Setting the ringer to a beep
) Hold down the key (approx. 3 seconds) until the "Beep" icon appears on
the
status bar on the display (ïƒ Page 24). You will hear a short beep every
25 seconds for as long as the caller stays on the line.
) To switch the function off again, hold down the key until the "Beep" icon
disappears from the status bar on the display.
or
Deactivating the ringtone via sensor key
Prerequisite: The "Ringer off" sensor key must be programmed (ïƒ Page 75).
S Press the "Ringer off" sensor key
An incoming call is signalled by a single ringtone burst.
R Press the illuminated sensor key once more to deactivate the "Ringer off"
function. The beep cannot be set using the sensor key.
To Next Page
Loading...
Need help?
General