Manual entry and parameter modifiers
You can change parameters manually by toggling between parameter values or using a
pop-up screen to enter specific values.
Change a parameter unit
The units of measure for NIBP can be manually changed on the Home tab.
Touch the NIBP frame.
The NIBP changes between SYS/DIA and MAP.
Note An authorized person can change the temperature unit of
measure in Advanced settings.
Change a frame manually
1. Press and hold a frame, such as NIBP.
A pop-up dialog box appears.
2. Manually enter the value.
3. Touch OK.
The manual value appears in the frame on the screen.
Pop-up screens
When a pop-up screen appears, you cannot access any buttons or controls on the screen
behind the pop-up. The specified action on the pop-up screen must be accomplished or,
if allowed, actively dismissed or canceled, before other screens become active.
There are instances when multiple, layered pop-up screens occur. In these instances,
only the top pop-up screen is accessible. The specified action on the top pop-up screen
must be accomplished or, if allowed, actively dismissed or canceled, before the pop-up
screen behind becomes active.
Navigation
There are four types of navigation in the monitor:
•
Primary tabs
• Vertical tabs
• Command buttons
• Shortcuts
Primary tabs
The primary tabs at the bottom of the screen enable you to switch between tabs and
change the controls in the content area on the monitor. The profile you choose
determines which tabs are available. The tab you choose determines what information
appears on the screen. The five primary tabs are
•
Home
40 Startup Connex
®
Spot Monitor
To Next Page
Loading...
Need help?
General
