1. Touch the Patient tab.
2. Touch in any field and then enter patient information.
3. Touch Next to cycle through the patient data fields.
Note You can use a barcode scanner to enter a patient ID in the
Patient ID field. Touch in the Patient ID field, scan
the barcode, and touch OK.
4. Touch OK to save and return to the Home tab.
Manage patient records
Patient records can be sent to the network or deleted.
1.
Touch the Review tab.
Note Measurements that triggered a physiological alarm are
highlighted on this tab.
2. Select patients by touching the check box next to their names.
3. Touch Send to transmit the records to the network or Delete to permanently
remove the records as desired.
CAUTION Verify patient identity on the monitor after
manual or barcode entry and before transferring patient
records.
Note The icon indicates the records have been sent to the
network.
Note You can configure the Intervals profile, to automatically send
measurements to the network.
Note Patient measurements older than 24 hours are automatically
deleted from the patient records list on the Review tab.
44 Patient data management Connex
®
Spot Monitor
To Next Page
Loading...
Need help?
General
