FreeFlow Process Manager Operator and Administrator Guide
2-96
Workflow Builder
About Job types
The following job types are available via the Imposition Settings
dialog:
• Standard: The pages are printed in a sequential order with
one page on one side of a sheet of defined paper stock. There
is one Standard job type, for which you can specify the image
orientation and sides imaged.
• Signature: Two separate pages are printed side-by-side on
one side of a sheet of paper. All Signature documents are 2-
sided. The pages of the document are sequenced when
printed to produce output that can be folded to create a
booklet type of document. There are three signature job types,
each characterized by the fold (binding edge) of the document:
– Signature Booklet: Portrait, fold (binding edge) is parallel
to short edge of the stock
– Signature Calendar: Head to Toe orientation, fold
(binding edge) is parallel to short edge of the stock
– Signature Pamphlet: Portrait orientation, fold (binding
edge) is parallel to the long edge of the stock
• N-up: The pages are printed in sequential order with each
page of the document appearing a specified number of times
(n) on the same side of a sheet of paper. (This is also known
as multiple imposition or tiling.) Each copy of the page is called
a cell. There are ten n-up job types:
– 2 Up: Each page is imaged twice on one side of a sheet of
paper.
– 2 Up Flip Left: Each page is imaged twice on one side of a
sheet of paper with the left of the two imaged pages flipped
180 degrees to appear upside down.
– 2 Up Flip Right: Each page is imaged twice on one side of
a sheet of paper with the right of the two imaged pages
flipped 180 degrees to appear upside down.
To Next Page
Loading...
Need help?
General
