143
Customize Menu Settings for Individual Use (Set Mode)
Set Mode: SCAN Menu Operations
Selecting a Receive Operation When Scanning Stops
Touch [4 SCAN RESUME] to set the receive operation for when scanning stops.
For details, see “Setting the Receive Operation When Scanning Stops” on page 74.
Setting the Scanning Range
You can set the frequency range for scanning in VFO mode and Memory mode.
1 Touch [5 SCAN WIDTH].
2 Rotate the DIAL to select [VFO], then press the key.
3 Rotate the DIAL to select the desired setting referring to the table below.
ALL
Scans all bands from the current frequency within the 1.8 MHz to 999
MHz range.
BAND Starting with the current frequency, scans within the current band.
4 Press the key.
5 Rotate the DIAL to select [MEMORY], then press the key.
6 Rotate the DIAL to select the desired setting referring to the table below.
ALL CH
Scans all memory channels (1 to 900) starting with the currently specified
memory channel. When “Selected memory channel” is selected, all
specified memory channels are scanned (
see page 76).
BAND
Scans only the memory channels to which the frequencies are registered,
within the same frequency band
*1
as the currently specified memory
channel.
When the memory channels are registered as the specified memory
channels, scans only the specified memory channels to which the
frequencies are registered, within the same frequency band.
*1
*1: For the relationship between frequency bands and receive frequencies, see the table at the
bottom of page 36.
To Next Page
Loading...
Need help?
General
