Yaesu FT2DR User Manual

44
Basic Operation
Miscellaneous Settings
8 Rotate the DIAL to select the minute, then press the
key.
Tip If GPS information is received, the time will be set
automatically.
9 To activate the time signal (alarm goes off every hour on
the hour), touch [SIGNAL ON].
The checkbox will be checked.
10 Touch [OK].
The transceiver exits from Set mode.
Remark The current time appears on the LCD.
Tips
• At normal temperature, the time deviation is ±30 seconds per month. It may vary depending on the
environment conditions, such as the temperature .
• The transceiver is equipped with a rechargeable lithium battery dedicated for the clock. Normally,
the transceiver is powered from the battery pack. When the battery pack is detached or runs
out, the lithium battery starts operating automatically. The lithium battery can power the clock for
approximately 2 months.
• When you use the transceiver for the first time or without the battery pack for a long period of time,
the accuracy of the clock may be poor. In such case, reattach the battery pack and adjust the time.
• The calendar can display dates from January 1, 2000 A.D. up to December 31, 2099 A.D.
• Press and hold
for over one second to enter Set mode, then select [APRS] → [21 GPS TIME
SET] followed by [AUTO] to display accurate time automatically.
• Using the timer function enables the transceiver to automatically turn off at a specified time (
see
page 149). In addition, you can set the transceiver to turn on at a specified time (
see page 149).
Muting Audio
If the A-band and B-band are heard simultaneously during dual receive, and it is difficult
to hear the voices, the audio of the non-operating band may be muted.
1 Press and hold the key for over one second.
The transceiver enters Set mode.
2 Touch [TX/RX].

Yaesu FT2DR Specifications

General

Brand	Yaesu
Model	FT2DR
Category	Transceiver
Language	English