80
Memory Channel Scanning
8 Press the key to enter Memory mode.
9 Touch [F MW].
10 Touch [BANK].
11 Press the key.
12 Rotate the DIAL to select the memory bank to begin memory scanning from.
The memory bank number is changed from [B] to [b] and
the bank link scanning is activated.
13 Press the key.
The memory banks for which you perform memory bank
link scanning are determined.
14 Touch [F MW].
The function menu screen appears.
15 Touch [SCAN].
Tips • Scanning is performed toward the higher memory
channel numbers.
• Rotate the DIAL clockwise: Scanning is performed
toward the higher memory channel numbers.
• Rotate the DIAL counterclockwise: Scanning is performed toward the lower
memory channel numbers.
• When a signal is received during scanning, scanning stops for 5 seconds and
this frequency is received.
• When scanning is suspended, the decimal point blinks and the LCD stays lit.
• After receiving the frequency for 5 seconds, scanning resumes.
• To stop scanning, touch [STOP] or press .
• You can select the range for scanning by pressing and holding the key for
over one second to enter Set mode, then selecting
[SCAN] → [5 SCAN WIDTH].
y Canceling Bank Link Scanning
1 Press and hold the key for over one second.
The transceiver enters Set mode.
2 Touch [MEMORY].
3 Touch [1 BANK LINK].
4 Rotate the DIAL to select the memory bank.
5 Press the key.
The memory bank display is changed from ☒ to □ and the bank link scanning is
deactivated.
6 Repeat steps 4 and 5 to select other memory banks.
7 Press .
The transceiver exits from Set mode.
The memory bank number is
changed from [B] to [b]
To Next Page
Loading...
Need help?
General
