YOKOGAWA AQ6370C User Manual

7-77
IM AQ6370C-17EN
Remote Commands
1
2
3
4
5
6
7
8
App
Index
INITiate Sub System Command
:INITiate[:IMMediate]
Function Makes a sweep.
Syntax
:INITiate[:IMMediate]
Example
:INITIATE
Explanation • You can stop sweep with the
:ABORt
command.
• The sweep mode (AUTO, SINGLE, REPEAT,
or SEGMENT MEASURE) is set using the
:INITiate:SMODe
command.
• If this command is executed while the sweep
mode is in REPEAT (
:INITiate:SMODe
REPeat
), the operation of the command is
complete at the instant a sweep starts. In
this case, this command is regarded as a
sequential command.
• If this command is executed while the
sweep mode is one of AUTO, SINGLE, and
SEGMENT MEASURE, the operation of the
command is complete at the instant a sweep
ends. In this case, this command is regarded
as a command subject to overlapping.
:INITiate:SMODe
Function Sets/queries the sweep mode.
Syntax
:INITiate:SMODe<wsp><sweep mode>
:INITiate:SMODe?
<sweep mode> = Sweep mode
SINGle = SINGLE sweep mode
REPeat = REPEAT sweep mode
AUTO = AUTO sweep mode
SEGMent = SEGMENT
Response 1 = SINGle
2 = REPeat
3 = AUTO
4 = SEGMent
Example
:INITIATE:SMODE REPEAT
:INITIATE:SMODE? -> 2
Explanation This is a sequential command.
MEMory Sub System Command
:MEMory:CLEar
Function Clears the contents of a specified waveform
memory.
Syntax
:MEMory:CLEar<wsp><integer>
<integer> = Memory number
Example
:MEMORY:CLEAR 10
Explanation • No execution error occurs even if a specified
waveform memory has already been cleared.
• This is a sequential command.
:MEMory:EMPTy?
Function Queries the condition of whether a waveform
has been specified in a specified waveform
memory.
Syntax
:MEMory:EMPTy?<wsp><integer>
<integer> = Memory number
Example
:MEMORY:EMPTY? 10 -> 1
Explanation This is a sequential command.
:MEMory:LOAD
Function Loads a waveform from a specified waveform
memory into a specified trace.
Syntax
:MEMory:LOAD<wsp><integer>,<trace
name>
<integer> = Memory number
<trace name> = trace
(TRA,TRB,TRC,TRD,TRE,TRF,TRG)
Example
:MEMORY:LOAD 10,TRA
Explanation • When a waveform is not registered in the
specified waveform memory, a warning
message appears.
• This is a sequential command.
:MEMory:STORe
Function Stores the waveform of a specified trace into a
specified waveform memory.
Syntax
:MEMory:STORe<wsp><integer>,<trace
name>
<integer> = Memory number
<trace name>= trace
(TRA,TRB,TRC,TRD,TRE,TRF,TRG)
Example
:MEMORY:STORE 10,TRA
Explanation • When waveform data do not exist in the
specified trace, a warning message appears.
• This is a sequential command.
7.6 Instrument-Specific Commands

YOKOGAWA AQ6370C Specifications

General

Brand	YOKOGAWA
Model	AQ6370C
Category	Measuring Instruments
Language	English