Cradle Installation
138
2. Insert power cable through a cable outlet of cradle back housing.
3. Plug connector into power connector on printed circuit board.
4. If more than one cradle is being installed, connect the interconnect cable from the first cradle to the second
cradle.
Figure 97 Daisy-Chaining Cradles
5. Use plugs to cover un-used cable outlets.
Figure 98 Cable Hole Plug Installation
Assembly
1. Replace cover.
2. Secure cover with screws.
Interconnect Cable 25-66431-01R
To Next Page
Loading...
Need help?
General
