Safety instructions
17
General safety
These instructions are intended for all who install and service the drive.
WARNING! Ignoring the following instructions can cause physical injury or death,
or damage to the equipment:
•
Handle the unit carefully.
•
The drive module is heavy 200 kg (441 lb). Lift it by the upper part only using
the lifting lugs attached to the top of the unit. The lower part will be deformed
from lifting. Do not remove the pedestal before lifting.
Do not tilt the drive. The centre of gravity of the unit is high. The unit will
overturn from a tilt of about 6 degrees. An overturning unit can cause
physical injury.
•
Beware of hot surfaces. Some parts, such as heatsinks of power
semiconductors, remain hot for a while after disconnection of the electrical
supply.
•
Make sure that dust from borings and grindings does not enter the drive when
installing. Electrically conductive dust inside the unit may cause damage or
malfunctioning.
•
Ensure sufficient cooling.
•
Do not fasten the drive by riveting or welding.
Do not lift by the lower
part of the frame.
M
a
x
3
0
°
Do not tilt!
To Next Page
Loading...
Need help?
General
