ABB ACS880 PCP User Manual

106 Parameters
01.14 Output power Drive output power. The unit is selected by parameter
96.16 Unit selection. A filter time constant for this signal
can be defined by parameter 46.14 Filter time power out.
-
-32768.00
…32767.00 kW or hp
Output power. 1 = 1 unit
01.15 Output power % of
motor nom
Shows the value of 01.14 Output power in percent of the
nominal power of the motor.
-
-300.00 … 300.00% Output power. 1 = 1%
01.17 Motor shaft power Estimated mechanical power at motor shaft. The unit is
selected by parameter 96.16 Unit selection.
-
-32768.00 …
32767.00 kW or hp
Motor shaft power. 1 = 1 unit
01.18 Inverter GWh
motoring
Amount of energy that has passed through the drive
(towards the motor) in full gigawatt-hours. The minimum
value is zero.
-
0...32767 GWh Motoring energy in GWh. 1 = 1 GWh
01.19 Inverter MWh
motoring
Amount of energy that has passed through the drive
(towards the motor) in full megawatt-hours. Whenever the
counter rolls over, 01.18 Inverter GWh motoring is
incremented.The minimum value is zero.
-
0...1000 MWh Motoring energy in MWh. 1 = 1 MWh
01.20 Inverter kWh
motoring
Amount of energy that has passed through the drive
(towards the motor) in full kilowatt-hours. Whenever the
counter rolls over, 01.19 Inverter MWh motoring is
incremented.The minimum value is zero.
-
0...1000 kWh Motoring energy in kWh. 10 = 1 kWh
01.21 U-phase current Measured U-phase current. -
-30000.00 …
30000.00 A
U-phase current. -
01.22 V-phase current Measured V-phase current. -
-30000.00 …
30000.00 A
V-phase current. -
01.23 W-phase current Measured W-phase current. -
-30000.00 …
30000.00 A
W-phase current. -
01.24 Flux actual % Used flux reference in percent of nominal flux of motor. -
0...200% Flux reference. 1 = 1%
01.29 Speed change rate Rate of actual speed change. Positive values indicate
acceleration, negative values indicate deceleration.
See also parameters 31.32 Emergency ramp supervision,
31.33 Emergency ramp supervision delay, 31.37 Ramp
stop supervision and 31.38 Ramp stop supervision delay
.
-
-15000...15000 rpm/s Rate of speed change. 1 = 1 rpm/s
No. Name/Value Description Def/
FbEq16

ABB ACS880 PCP Specifications

General

Output current	Up to 5200 A
Input voltage	380-690 V
Power range	5600 kW
Cooling method	Air or liquid
Protection class	IP21, IP54
Communication interfaces	Ethernet, CANopen