ABB | SACE Emax 2
Putting into service and maintenance | 2 - Identification of alarms or failures
93 | © 2014 ABB | 1SDH000999R0002 - L8569
2 - Identification of alarms or failures
Introduction
The protection release is able to identify some faults and to signal them through LEDs or the display; you need
to identify the cause and eliminate it before re-closing the circuit-breaker, both locally and remotely.
WARNING! identification of the faults must be managed only by Expert Persons in the
electrical area (IEV 195-04-01: Person with sufficient training and experience to allow him/
her to perceive the risks and to avoid the hazards potentially created by electricity). Indeed,
it may be necessary to perform insulation and dielectric tests on part or all of the
installation.
Some failures involve partial operation of the circuit-breaker. Consult the paragraphs “Faults, causes and
remedies” on page 94 and “Faults signalled on the display” on page 97 where the possible causes of the main
faults are listed.
Further information on the Ekip Touch release and on the accessories mentioned in this chapter and which are
not covered in this manual are available from the web site http://www.abb.com/abblibrary/DownloadCenter/,
with the Ekip Touch manual 1SDH001316R0002.
To Next Page
Loading...
Need help?
General
