Rockwell Automation Publication 2094-UM001J-EN-P - March 2017 145
Configure and Start the Kinetix 6000 Drive System Chapter 6
6. Click the Sercos Interface tab and reference the table below.
7. Verify that the Data Rate setting matches DIP switches 2 and 3
(communication rate), as set on the IAM and AM module, or choose
the Auto Detect setting.
8. From the Cycle Time pull-down menu, choose the Cycle Time
according to the table below.
9. From the Transmit Power pull-down menu, choose High.
The default setting is High, however this setting is dependent on the
cable length (distance to next receiver) and cable type (glass or plastic).
10. Enter the Transition to Phase setting.
The Transition to Phase default setting is 4 (phase 4). The Transition to
Phase setting stops the ring in the phase specified.
11. Click OK.
12. Repeat step 1
through step 11 for each Logix5000 module.
Logix5000 Sercos Module Number of Axes Data Rate
1756-M03SE or
1756-L60M03SE
Up to 3
4 or 8 Mbps
1756-M08SE Up to 8
1756-M16SE or
1784-PM16SE
Up to 16
1768-M04SE Up to 4
Data Rate Number of Axes Cycle Time
4 Mbps
Up to 2 0.5 ms
Up to 4 1 ms
Up to 8 2 ms
No support for axes 9…16
8 Mbps
(1)
(1) The Kinetix 6000M IDM system supports only 8 Mbps and is hardwired for this setting.
Up to 4 0.5 ms
Up to 8 1 ms
Up to 16 2 ms
TIP The number of axes/module is limited to the number of axes as
shown in step 6
.
To Next Page
Loading...
Need help?
General
