Programming Overview
4–15
The programming device allows you to enter a ladder logic program into the micro
controller.
In the following illustration, the electromechanical circuit shows PB1 and PB2, two
pushbuttons, wired in series with an alarm horn. PB1 is a normally open
pushbutton, and PB2 is normally closed. This same circuit is shown in ladder logic
by two contacts wired in series with an output. Contact I/0 and I/1 are
examine-if-closed instructions.
➀
(For more information on this instruction, refer to
page 6–4.)
Electromechanical Circuit
Alarm
Horn
PB1 PB2
1
] [] [
( )
O
1
I
Ladder Logic Program
0
I
➀
Contact
I1 would be an examine-if-open instruction ( ]/[ ) if PB2 was a normally open electromechanical circuit.
The
table below shows how these circuits operate. The table shows all possible
conditions for the electromechanical circuit, the equivalent state of the ladder logic
instructions, and the resulting output state.
If PB1 is: I/0 state is: And PB2 is: I/1 state is: Then the Alarm Horn (O/1) is:
not pushed 0 not pushed 1 silent
not pushed 0 pushed 0 silent
pushed 1 not pushed 1 alarm
pushed 1 pushed 0 silent
Developing
Y
our Logic Program – A Model
The following diagram can help you develop your application program. Each
process block represents one phase of program development. Use the checklist at
the right of the process block to help you identify the tasks involved with each
process.
Programming
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
To Next Page
Loading...
Need help?
General
