Publication 1785-UM012D-EN-P - July 2005
7-16 Communicating with a PLC-5 Adapter Channel
Each group/module that is programmed as an adapter channel block transfer
uses one byte in the adapter channel’s input destination file.
For example:
Use care when planning block-transfer and discrete transfers of data to an
adapter-mode controller channel.
0003040710131417 0003040708111215Word
0
1
2
3
4
5
6
7
Output File
Input File
for status.
Adapter Channel’s Input Destination File
Example Integer File
Scanner’s Output Image Table
module 0
module 1
A block transfer request for group 3, module 0
uses these bytes in the file. This byte is now
unavailable for discrete data transfer.
locations of module 0 and 1 data
ATTENTION
Use caution when performing data transfer. The
discrete output data is over-written by the block
transfer control on a group/module basis. If you write
both types of transfer to the same group slot,
unpredictable machine operation and possible damage
to equipment or injury to personnel can occur.
To Next Page
Loading...
Need help?
General
