soc-2
Manual Updates
The information below summarizes the changes to the PowerFlex 400
User Manual since the April 2005 release.
New Parameters
The following new parameters have been added with the release of
Firmware Release Number (FRN) 3.xx.
Description of New or Updated Information See Page(s)
Attention statement clarified. 1-6
Min/Max wire sizes for Frame F corrected. 1-15
Note added regarding the function of I/O Terminal 18, Analog Common 2. 1-17
Connection Examples corrected for Analog Input and Analog Output. 1-20
Required filters corrected for 380-480V, 2.2-11 kW (3.0-15 HP) drives in
First Environment Unrestricted.
1-28
Important statement regarding differences in parameter defaults for
packaged drives added to parameter P041 [Reset To Defalts].
3-11
Fault F64 Drive Overload description corrected. 4-4
Overcurrent protection for hardware limit and instantaneous fault levels
corrected.
A-3
Max storage temperatures corrected to 70 degrees C (158 degrees F). A-3
Max and Actual Short Circuit Ratings added to Electrical specification. A-4
Optional Relay specifications added. A-5
Supported communication protocols expanded. A-5
Watts Loss table added. A-6
Power Structure detail added to Appendix A. A-7
Appendix D provides setup information for Damper Control, PID Control,
and Auxiliary Control schemes.
D-1
Appendix G, P1 network protocol added. G-1
Parameter Name Parameter Number See Page(s)
[Motor OL Ret] P043 3-11
[Anlg Loss Delay] T088 3-26
[Start Source 2] C108 3-29
[Speed Ref 2] C109 3-30
To Next Page
Loading...
Need help?
General
