R5906112 /09 UDX series164
10.2.3 IR sensors
What can be done?
Each IR sensor can be individually disabled or enabled.
When all sensors are turned off, the projector will no longer respond to signals from the remote control. To re-
enable the sensors, use the menu keypad on the projector.
How to disable
1. In the main menu, select System Settings → Communication → IR Control.
Image 10-15: Communication menu, IR control
The IR control menu is displayed.
Image 10-16: IR control menu
2. To disable an IR sensor, select the slider and drag to the left.
A blue slider means an active IR sensor.
A gray slider means an inactive IR sensor.
3. Select APPLY and click OK to apply the changes.
GUI – System Settings
To Next Page
Loading...
Need help?
General
