R5906112 /09 UDX series172
10.9 Disabling Standby mode
When to disable standby mode
Until recently, it was not possible to navigate through the on-screen display (OSD) of the projector while in
Ready mode. This feature has been implemented from software version 1.7 onward.
However, by default the projector will automatically go to standby mode after 15 minutes as a power-saving
functionality. While in Standby mode, it is no longer possible to use the OSD for anything other than a status
overview. In order to prevent the projector from transitioning to this power-saving mode, you can now disable
Standby mode.
How to disable/enable standby mode
1. In the main menu, select System Settings.
2. In the System Settings menu, select if you want to enable or disable Standby mode by using the slider
underneath Standby.
Image 10-30: System Settings Menu, Enable Standby mode
GUI – System Settings
To Next Page
Loading...
Need help?
General
