R5906113 /08 UDX 95
• Chosen source
• Current resolution and refresh rate
• Chosen communication method and IP address (if connected)
• Active functions
Starting image projection
1. Make sure the available sources are connected to the appropriate input ports.
Tip: If properly connected, the “SYNC” LED will light up ORANGE.
2. Press the Input Selection button on the keypad or on the remote control until:
• the LED of the selected source (the “SEL” LED) lit up GREEN, and
• the image of the selected source is projected.
Image 9-3
9.2 Switching to standby
How to switch to standby
1. Press and hold the Power on/off button for 3 seconds on the local keypad, or press the Power Off button on
the remote control.
The projector goes to standby mode. The after-cooling cycle will start (about 30 seconds). During this period
the Power on/off button will blink. Once the after-cooling cycle has ended, the projector will be in standby
mode and the Power on/off button will be lit WHITE.
Image 9-4
9.3 Power off projector
CAUTION: This procedure assumes the projector is in standby mode.
Getting Started
To Next Page
Loading...
Need help?
General
