APPENDIX ——————————————————————————————————————————————————————————————————————————
246
3
Use the included cleaning brush to remove
any lint and dust from the hook and its
surrounding area.
CAUTION
4
After cleaning is finished, insert the bobbin
case into the hook, and then close the hook
cover. (Refer to page 36, 37.)
Cleaning around the needle
plate
If lint and dust collect around the moving knife, the
fixed knife or the thread retaining plate, the thread
may not be cut correctly and the error message
may appear, or various parts of the machine may
be damaged. Make sure to clean around the needle
plate once a month.
Use on offset screwdriver and the included
cleaning brush.
1
Turn off the embroidery machine.
CAUTION
2
Remove the needle plate.
With an offset screwdriver, loosen the
screws, and then remove the needle plate.
1 Needle plate
● If the hook is scratched or damaged,
consult your authorized dealer.
● Unplug the power supply cord before
cleaning the machine, otherwise
injuries or an electric shock may occur.
To Next Page
Loading...
Need help?
General
