Edit Accessible IP Address Screen/Add Accessible IP Address Screen
Note
This screen is not available depending on the printer you are using.
The example screenshots in this section refer to the Add Accessible IP Address Screen.
1.
Specification Method:
Select either Single Address Specification or Range Specification to add the IP address(es).
Single Address Specification
Specify each IP address separately.
Range Specification
Specify a range of successive IP addresses.
2. IP Address:
Enter the IP address of a computer or a network device to allow access when you selected Single Address
Specification in Specification Method:.
An IP address is expressed as four values ranging from 0 to 255.
Start IP Address:
Enter the first IP address in the range of addresses of the computers or network devices to allow access when you
selected Range Specification in Specification Method:.
An IP address is expressed as four values ranging from 0 to 255.
End IP Address:
Enter the last IP address in the range of addresses of the computers or network devices to allow access when you
selected Range Specification in Specification Method:.
An IP address is expressed as four values ranging from 0 to 255.
Note
The Start IP Address: must be a smaller value than the End IP Address:.
3.
Comment:
Optionally enter any information to identify the device, such as the name of the computer.
Important
Comments will be displayed only on the computer used to enter them.
176
To Next Page
Need help?
General
