Starting Up Speed Dial Utility
Before starting up Speed Dial Utility, confirm the following:
• The necessary application software (MP Drivers and Speed Dial Utility)
is installed.
If the application software (MP Drivers and Speed Dial Utility) is not yet installed, insert the Setup CD-
ROM into the computer's disc drive, then install MP Drivers and Speed Dial Utility.
•
The machine is connected to a computer correctly.
Make sure that the machine is connected to the computer correctly.
Do not plug in or unplug any cables while the machine is in operation, or when the computer is in sleep
or standby mode.
If your machine is compatible with LAN connection, make sure that the machine is connected to the
computer with LAN connection to use Speed Dial Utility via LAN connection.
Follow the procedure below to start up Speed Dial Utility.
1. Make sure that the machine is turned on.
2.
Click Start and select All programs, Canon Utilities, Speed Dial Utility, and then
Speed Dial Utility.
Speed Dial Utility starts up.
Note
You can also start up the Speed Dial Utility by clicking Speed Dial Settings from Device
Settings & Maintenance on Quick Menu.
To Next Page
Loading...
Need help?
General
