Canon IJ Network Tool Screen
This section describes the items and menus displayed on the Canon IJ Network Tool screen.
Items on the Canon IJ Network Tool Screen
Canon IJ Network Tool Menus
Items on the Canon IJ Network Tool Screen
The following item is displayed on the Canon IJ Network Tool screen.
1.
Printers:
The printer name, status, printer model name, and port name are displayed.
A check mark next to the printer in the Name list indicates it is set as the default printer.
Configuration changes are applied to the selected printer.
2.
Update
Performs printer detection again. Click this button if the target printer is not displayed.
Important
To change the printer's network settings using IJ Network Tool, it must be connected via a LAN.
If No Driver is displayed for the name, associate the port with the printer.
When the Printer Driver Is Not Associated with a Port
If Not Found is displayed for the status, check the followings:
The access point is turned on.
When using wired LAN, the LAN cable is connected properly.
If the printer on a network is not detected, make sure that the printer is turned on, then click Update. It may take
several minutes to detect printers. If the printer is not yet detected, connect the machine and the computer with a
USB cable, then click Update.
If the printer is being used from another computer, a screen is displayed informing you of this condition.
Note
This item has the same function as Refresh in the View menu.
3.
Configuration...
Click to configure settings of the selected printer.
Configuration Screen
Note
You cannot configure a printer that has the status Not Found.
This item has the same function as Configuration... in the Settings menu.
Canon IJ Network Tool Menus
The following menu is displayed from the Canon IJ Network Tool screen.
178
To Next Page
Loading...
Need help?
General
