Cisco Catalyst 250 Series User Manual

CHAPTER 10
Configuring IPv4 ACLs
•
Finding Feature Information, page 139
•
Prerequisites for Configuring IPv4 Access Control Lists, page 139
•
Restrictions for Configuring IPv4 Access Control Lists, page 140
•
Information about Network Security with ACLs, page 141
•
How to Configure ACLs, page 154
•
Monitoring IPv4 ACLs, page 179
•
Configuration Examples for ACLs, page 180
•
Additional References, page 194
•
Feature Information for IPv4 Access Control Lists, page 195
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring IPv4 Access Control Lists
This section lists the prerequisites for configuring network security with access control lists (ACLs).
•
On switches running the LAN base feature set, VLAN maps are not supported.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 139

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English