Cisco Catalyst 250 Series User Manual

PurposeCommand or Action
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 8
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 9
startup-config
Monitoring IPv6 ACLs
You can display information about all configured access lists, all IPv6 access lists, or a specific access list by
using one or more of the privileged EXEC commands shown in the table below:
PurposeCommand
Displays all access lists configured on the switch.show access-lists
Displays all configured IPv6 access lists or the access
list specified by name.
show ipv6 access-list [access-list-name]
Displays VLAN access map configuration.
show vlan access-map[map-name]
Displays the mapping between VACLs and VLANs.
show vlan filter[access-mapaccess-map| vlanvlan-id]
This is an example of the output from the show access-lists privileged EXEC command. The output shows
all access lists that are configured on the switch or switch stack.
Switch # show access-lists
Extended IP access list hello
10 permit ip any any
IPv6 access list ipv6
permit ipv6 any any sequence 10
This is an example of the output from the show ipv6 access-list privileged EXEC command. The output
shows only IPv6 access lists configured on the switch or switch stack
Switch# show ipv6 access-list
IPv6 access list inbound
permit tcp any any eq bgp (8 matches) sequence 10
permit tcp any any eq telnet (15 matches) sequence 20
permit udp any any sequence 30
IPv6 access list outbound
deny udp any any sequence 10
deny tcp any any eq telnet sequence 20
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 205
Configuring IPv6 ACLs
Monitoring IPv6 ACLs

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English