Cisco Catalyst 250 Series User Manual

Verifying the DAI Configuration
To display and verify the DAI configuration, use the following commands:
DescriptionCommand
Displays detailed information about ARP ACLs.
show arp access-list [acl-name]
Displays the trust state and the rate limit of ARP
packets for the specified interface or all interfaces.
show ip arp inspection interfaces [interface-id]
Displays the configuration and the operating state of
dynamic ARP inspection for the specified VLAN. If
no VLANs are specified or if a range is specified,
displays information only for VLANs with dynamic
ARP inspection enabled (active).
show ip arp inspection vlan vlan-range
Additional References
Error Message Decoder
LinkDescription
https://www.cisco.com/cgi-bin/Support/Errordecoder/
index.cgi
To help you research and resolve system error
messages in this release, use the Error Message
Decoder tool.
MIBs
MIBs LinkMIB
To locate and download MIBs for selected platforms,
Cisco IOS releases, and feature sets, use Cisco MIB
Locator found at the following URL:
http://www.cisco.com/go/mibs
All supported MIBs for this release.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
260 OL-29048-01
Configuring Dynamic ARP Inspection
Verifying the DAI Configuration

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English