PurposeCommand or Action
• inactivity—Sets the aging type as inactivity aging. The secure
addresses on this port age out only if there is no data traffic
from the secure source addresses for the specified time period.
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 5
Verifies your entries.
show port-security [interface interface-id]
[address]
Step 6
Example:
Switch# show port-security interface
gigabitethernet1/0/1
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 7
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 8
Related Topics
Port Security Aging, on page 408
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 417
Configuring Port-Based Traffic Control
Finding Feature Information
To Next Page
Loading...
Need help?
General