Cisco Catalyst 250 Series User Manual

CHAPTER 11
Configuring IPv6 ACLs
•
Finding Feature Information, page 197
•
IPv6 ACLs Overview, page 197
•
Restrictions for IPv6 ACLs, page 199
•
Default Configuration for IPv6 ACLs , page 199
•
Configuring IPv6 ACLs, page 200
•
Attaching an IPv6 ACL to an Interface, page 203
•
Monitoring IPv6 ACLs, page 205
•
Additional References, page 206
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
IPv6 ACLs Overview
You can filter IP Version 6 (IPv6) traffic by creating IPv6 access control lists (ACLs) and applying them to
interfaces similar to how you create and apply IP Version 4 (IPv4) named ACLs. You can also create and
apply input router ACLs to filter Layer 3 management traffic when the switch is running IP base and LAN
base feature sets.
A switch supports three types of IPv6 ACLs:
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 197

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English