Cisco Catalyst 250 Series User Manual

PurposeCommand or Action
or
Switch(config-if)# ipv6 nd inspection vlan 222, 223,224
Verifies that the policy is attached to the specified
interface without exiting the interface configuration
mode.
do show running-config
Example:
Switch#(config-if)# do show running-config
Step 4
How to Attach an IPv6 Neighbor Discovery Inspection Policy to a Layer 2
EtherChannel Interface
Beginning in privileged EXEC mode, follow these steps to attach an IPv6 Neighbor Discovery Inspection
policy on an EtherChannel interface or VLAN:
SUMMARY STEPS
1.
configure terminal
2.
interface range Interface_name
3.
ipv6 nd inspection [attach-policy policy_name [ vlan {vlan_ids | add vlan_ids | except vlan_ids | none
| remove vlan_ids | all} ] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none | remove vlan_ids |
all} ]
4.
do show running-config interfaceportchannel_interface_name
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specify the port-channel interface name assigned when
the EtherChannel was created. Enters the interface range
configuration mode.
interface range Interface_name
Example:
Switch(config)# interface Po11
Step 2
Enter the do show interfaces summary
command for quick reference to interface names
and types.
Tip
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
452 OL-29048-01
Configuring IPv6 First Hop Security
How to Attach an IPv6 Neighbor Discovery Inspection Policy to a Layer 2 EtherChannel Interface

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English