Cisco Catalyst 250 Series User Manual

PurposeCommand or Action
Attaches the ND Inspection policy to the interface or the
specified VLANs on that interface. The default policy
is attached if the attach-policy option is not used.
ipv6 nd inspection [attach-policy policy_name [ vlan
{vlan_ids | add vlan_ids | except vlan_ids | none | remove
vlan_ids | all} ] | vlan [ {vlan_ids | add vlan_ids |
exceptvlan_ids | none | remove vlan_ids | all} ]
Step 3
Example:
Switch(config-if-range)# ipv6 nd inspection
attach-policy example_policy
or
Switch(config-if-range)# ipv6 nd inspection
attach-policy example_policy vlan 222,223,224
or
Switch(config-if-range)#ipv6 nd inspection vlan 222,
223,224
Confirms that the policy is attached to the specified
interface without exiting the configuration mode.
do show running-config interfaceportchannel_interface_name
Example:
Switch#(config-if-range)# do show running-config int
po11
Step 4
How to Attach an IPv6 Neighbor Discovery Inspection Policy to VLANs Globally
Beginning in privileged EXEC mode, follow these steps to attach an IPv6 ND Inspection policy to VLANs
across multiple interfaces:
SUMMARY STEPS
1.
configure terminal
2.
vlan configuration vlan_list
3.
ipv6 nd inspection [attach-policy policy_name]
4.
do show running-config
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 453
Configuring IPv6 First Hop Security
How to Attach an IPv6 Neighbor Discovery Inspection Policy to VLANs Globally

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English