CHAPTER
1-1
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
1
Configuring VLANs
This chapter describes how to configure normal-range VLANs (VLAN IDs 1 to 1005) and
extended-range VLANs (VLAN IDs 1006 to 4094) on the Catalyst 3750-X or 3560-X switch. It includes
information about VLAN membership modes, VLAN configuration modes, VLAN trunks, and dynamic
VLAN assignment from a VLAN Membership Policy Server (VMPS). Unless otherwise noted, the term
switch refers to a Catalyst 3750-X or 3560-X standalone switch and to a Catalyst 3750-X switch stack.
Note For complete syntax and usage information for the commands used in this chapter, see the command
reference for this release.
The chapter consists of these sections:
• Understanding VLANs, page 1-1
• Configuring Normal-Range VLANs, page 1-4
• Configuring Extended-Range VLANs, page 1-10
• Displaying VLANs, page 1-14
• Configuring VLAN Trunks, page 1-14
• Configuring VMPS, page 1-26
Understanding VLANs
A VLAN is a switched network that is logically segmented by function, project team, or application,
without regard to the physical locations of the users. VLANs have the same attributes as physical LANs,
but you can group end stations even if they are not physically located on the same LAN segment. Any
switch port can belong to a VLAN, and unicast, broadcast, and multicast packets are forwarded and
flooded only to end stations in the VLAN. Each VLAN is considered a logical network, and packets
destined for stations that do not belong to the VLAN must be forwarded through a router or a switch
supporting fallback bridging, as shown in Figure 1-1. In a switch stack, VLANs can be formed with ports
across the stack. Because a VLAN is considered a separate logical network, it contains its own bridge
Management Information Base (MIB) information and can support its own implementation of spanning
tree. See Chapter 1, “Configuring STP.”
Note Before you create VLANs, you must decide whether to use VLAN Trunking Protocol (VTP) to maintain
global VLAN configuration for your network. For more information on VTP, see Chapter 1,
“Configuring VTP.”
To Next Page
Loading...
Need help?
General
