Dell EMC PowerEdge R7515 Service Manual

Figure 94. Removing the M.2 SSD module
Next steps
Replace the M.2 SSD module.
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 26.
2. Follow the procedure listed in the Before working inside your system on page 27.
3. Remove the air shroud.
4. Remove the BOSS card from the riser.
NOTE: The procedure to remove the BOSS card is similar to removing an expansion card.
Steps
1. Align the M.2 SSD module at an angle with the BOSS card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card.
NOTE:
The numbers on the image does not depict the exact steps. The numbers are just for representation of
sequence.
90 Installing and removing system components

Dell EMC PowerEdge R7515 Specifications

General

Brand	Dell
Model	EMC PowerEdge R7515
Category	Server
Language	English