4. Remove the display assembly.
5. Remove the display bezel.
6. Remove the display hinges.
7. Remove the display panel.
About this task
The following images indicate the location of the infrared camera and provide a visual representation of the removal procedure.
Steps
1. Peel the conductive tape that secures the IR camera cable in place.
2. Disconnect the IR camera cable from the connector on the camera module.
3. Carefully pry and lift the camera module from the display back cover.
Installing the infrared camera
Prerequisites
NOTE:
The infrared camera installation procedure is applicable only for Latitude 5330 laptop and not for the 2-in-1
configuration.
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the infrared camera and provides a visual representation of the installation
procedure.
102
Removing and installing components
To Next Page
Loading...
Need help?
General
