Next steps
1. Install the heat sink.
2. Install the fan.
3. Install the M.2 2280 SSD card or M.2 2230 SSD card.
4. Install the WWAN card (optional).
5. Install the WLAN card.
6. Install the 3-cell battery or 4-cell battery.
7. Install the base cover.
8. Install the SIM card.
9. Install the microSD card.
10. Follow the procedure in after working inside your computer.
Power-button and fingerprint reader
Removing the power button
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery or 4-cell battery.
4. Remove the WLAN card.
5. Remove the WWAN card (optional).
6. Remove the fan.
7. Remove the system board
NOTE:
The system board can be removed with the heat sink attached in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
About this task
The following images indicate the location of the power-button and provide a visual representation of the removal procedure.
56
Removing and installing components
To Next Page
Loading...
Need help?
General
