Dell PowerConnect 8132 User Manual

Managing a Switch Stack 169
Preconfiguring a Stack Member
To preconfigure a stack member before connecting the physical unit to the
stack, use the show support switchtype command to obtain the SID of the
unit to be added.
The example in this section demonstrates pre-configuring a PowerConnect
8024F switch on a stand-alone PowerConnect 8024 switch.
To configure the switch:
1
View the list of SIDs to determine which SID identifies the switch to
preconfigure.
console#show supported switchtype
2
Preconfigure the 8024F switch (SID = 2) as member number 2 in the
stack.
console#configure
console(config)#stack
console(config-stack)#member 2 2
console(config-stack)#exit
console(config)#exit
SID Switch Mode ID Code Type
------ ------------------------- ----------
1 PC8024 0x100b000
2 PC8024F 0x100b000

Dell PowerConnect 8132 Specifications

General

Brand	Dell
Model	PowerConnect 8132
Category	Switch
Language	English