EasyManuals Logo

Dell PowerConnect 8132 User Manual

Dell PowerConnect 8132
1294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #789 background imageLoading...
Page #789 background image
Snooping and Inspecting Traffic 789
Configuring IPSG
This example builds on the previous example and uses the same topology
shown in Figure 27-25. In this configuration example, IP source guard is
enabled on ports 1-20. DHCP snooping must also be enabled on these ports.
Additionally, because the ports use IP source guard with source IP and MAC
address filtering, port security must be enabled on the ports as well.
To configure the switch:
1
Enter interface configuration mode for the host ports and enable IPSG.
console(config)#interface range te1/0/1-20
console(config-if)#ip verify source port-security
2
Enable port security on the ports.
console(config-if)#port security
3
View IPSG information.
console#show ip verify source
--More-- or (q)uit
Interface Filter IP Address MAC Address Vlan
--------- ------- ----------
Te1/0/1 ip-mac 192.168.3.45 00:1C:23:55:D4:8E 100
Te1/0/2 ip-mac 192.168.3.40 00:1C:23:12:44:B6 100
Te1/0/3 ip-mac 192.168.3.33 00:1C:23:AA:B8:01 100
Te1/0/4 ip-mac 192.168.3.18 00:1C:23:67:D3:CC 100
Te1/0/5 ip-mac 192.168.3.49 00:1C:23:55:1B:6E 100

Table of Contents

Other manuals for Dell PowerConnect 8132

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 8132 and is the answer not in the manual?

Dell PowerConnect 8132 Specifications

General IconGeneral
BrandDell
ModelPowerConnect 8132
CategorySwitch
LanguageEnglish

Related product manuals