Dell PowerEdge R760 User Manual

Removing a power supply unit adapter
Remove the PSU adapter, when installing PSU with 86 mm wide form factor.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
Using a Phillips #1 screwdriver, loosen the screw and remove the power supply unit adapter.
Figure 242. Removing a power supply unit adapter
Next steps
1. Replace the PSU adapter or Install the PSU.
Installing a power supply unit adapter
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If required, Remove the PSU.
NOTE: Remove the PSU adapter, when installing PSU with 86 mm wide form factor.
Steps
1. Align and insert the power supply unit adapter.
2. Using a phillips #1 screwdriver, tighten the screw.
290
Installing and removing system components

Dell PowerEdge R760 Specifications

General

Form Factor	2U rack server
Processor	Intel Xeon Scalable Processors (4th Gen)
Memory	Up to 8TB DDR5
Drive Bays	Up to 24 x 2.5" SAS/SATA/NVMe (HDD/SSD)
Power Supply	Dual, hot-plug, redundant power supplies (800W, 1100W, 1400W options)
Network	1 x 1 GbE
RAID Controller	PERC H755, H355
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi, Microsoft Windows Server