Dell PowerEdge R760 User Manual

Name: Dell PowerEdge R760
Brand: Dell
Rating: 4 (1 reviews)

332 pages

To Next Page

To Previous Page

Figure 244. Removing a power supply unit

Next steps

1. Replace the PSU or install the PSU blank.

Installing a power supply unit

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions.

2. For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum

output power.

NOTE: The maximum output power (shown in watts) is listed on the PSU label.

3. If required, Remove the PSU blank.

Steps

Slide the PSU into the PSU bay until the release latch snaps into place.

292

Installing and removing system components

Questions and Answers:

Need help?

Do you have a question about the Dell PowerEdge R760 and is the answer not in the manual?

General

Form Factor	2U rack server
Processor	Intel Xeon Scalable Processors (4th Gen)
Memory	Up to 8TB DDR5
Drive Bays	Up to 24 x 2.5" SAS/SATA/NVMe (HDD/SSD)
Power Supply	Dual, hot-plug, redundant power supplies (800W, 1100W, 1400W options)
Network	1 x 1 GbE
RAID Controller	PERC H755, H355
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi, Microsoft Windows Server