Dell PowerVault TL2000 User Manual

Configure Library: Encryption
Note: Application Managed Encryption (AME) does not require a license key.
Library Managed Encryption requires a license key. Contact your TSR
(technical sales representative) to purchase this feature.
Important: The Advanced Encryption Settings are for Engineering Support use
only. These fields should always be set to "No Advanced Setting".
Prerequisites for Application Managed Encryption:
v SAS and Fibre Channel LTO Ultrium 4 Tape Drive (Full Height or Half Height)
Note: Fibre Channel is full height drive only.
v Ultrium 4 Tape Cartridge
v Library firmware level 5.80 or higher
v Drive firmware level 77BE or higher
v Tape backup software application that supports LTO4 encryption
Prerequisites for Library Managed Encryption
v SAS and Fibre Channel LTO Ultrium 4 Tape Drive (Full Height or Half Height)
Note: Fibre Channel is full height drive only.
v Ultrium 4 Tape Cartridge
v Library firmware level 5.80 or higher
v Drive firmware level 77BE or higher
v Dell Encryption Key Manager application
Setting or Changing a Drive's Method of Encryption
1. Enter your library's IP Address in an internet browser address field and press
ENTER.
2. Log in to the Web User Interface. Refer to “Login” on page 2-5.
3. Expand Configure Library in the left navigation pane.
4. Click Encryption.
5. On the Encryption screen, enter the Feature Activation Key to enable the
library managed encryption options.
6. Click Activate to save the key and expand the screen for additional encryption
settings.
a77ug199
Figure 5-39. Feature Activation Key screen
Chapter 5. Operations 5-47

Dell PowerVault TL2000 Specifications

General

Brand	Dell
Model	PowerVault TL2000
Category	Storage
Language	English