If you are not rackmounting your library, skip this procedure and go to “Attaching
the Library to a Server” on page 4-11.
Important: A 2U library weighs 15.59 kg (34.37 lbs.) with one drive and without
media. A 4U library weighs 21.32 kg (47 lbs.) with one drive and
without media.
To reduce the risk of personal injury or damage to the library:
1. observe local health and safety requirements and guidelines for
manual material handling,
2. obtain adequate assistance to lift and stabilize the library during
installation or removal, and
3. always remove all cartridges to reduce the overall weight of the
library.
To install your library in a rack, perform the following steps.
1. Verify that your rack kit includes the following contents (see Figure 4-4 on page
4-7):
v Packaged in plastic material:
– 2 rails (not shown)
– 2 mounting brackets (1)
v Packaged in the small bag with no label:
– 1 Torx wrench (5)
– 2 anchors (4)
– 2 countersunk screws for securing the anchors (6)
– 2 small countersunk screws for securing the tops of the mounting brackets
(7)
– 2 large screws to secure the mounting brackets to the rack (8)
v Packaged in the small bag with "Round Hole" on the label: 9 screws to be
used on racks with round holes. (2)
v Packaged in the small bag with "Square Hole" on the label: 9 screws to be
used on racks with square holes. (3)
4-6 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
To Next Page
Loading...
Need help?
General