XBee® Wi-Fi RF Modules
© 2013 Digi International, Inc. 114
Important Note:
Digi does not list the entire set of standards that must be met for each country. Digi
customers assume full responsibility for learning and meeting the required guidelines
for each country in their distribution market. For more information relating to European
compliance of an OEM product incorporating the XBee RF Module, contact Digi, or refer
to the following web sites:
CEPT ERC 70-03E - Technical Requirements, European restrictions and general
requirements: Available at
www.ero.dk/.
R&TTE Directive - Equipment requirements, placement on market: Available
at
www.ero.dk/.
Approved Antennas
When integrating high-gain antennas, European regulations stipulate EIRP power
maximums. The following antennas are approved for use with the XBee Wi-Fi Module:
• Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-
HABSM)
• PCB Antenna (0 dBi)
• Wire Whip Antenna (1.5 dBi)
Canada (IC)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement
Labeling Requirements
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly
visible label on the outside of the final product enclosure must display the following
text:
XBee Wi-Fi Through-hole:
Contains Model XBEES6B Radio, IC: 1846A-XBS6B
XBee Wi-Fi Surface Mount:
Contains Model S6BSM Radio, IC: 1846A-S6BSM
To Next Page
Loading...
Need help?
General
