EasyManuals Logo
Home>Doosan>Engine>GC25P-3

Doosan GC25P-3 User Manual

Doosan GC25P-3
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #143 background imageLoading...
Page #143 background image
- 142 -
LP Engine G430(3.0L) Base Engine Service Procedure
Distributor Lower Bushing
and Thrust Washer Removal
Tools Required
• J 9534 Distributor Lower Bushing Remover
• J 6585 Slide Hammer
1. Install the J 9534 into the distributor lower bushing.
2. Use the 6585 in order to remove the bushing.
3. Use a drift punch up through the bushing bore in order
to drive the thrust washer (if installed) our of the bore.
4. Clean the bushing bore in the cylinder block and
inspect for burrs or damage.
Oil Filter Bypass Valve Removal
and Installation
1. Check the spring and fiber valve for operation.
2. Inspect for a cracked or broken valve.
3. Use a screwdriver in order to pry the valve out.
4. Use a 9/16 in thin-wall deep socket in order to tap
the new bypass valve in place.
VE058-3L
VE057-3L
VE056-3L

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Doosan GC25P-3 and is the answer not in the manual?

Doosan GC25P-3 Specifications

General IconGeneral
BrandDoosan
ModelGC25P-3
CategoryEngine
LanguageEnglish

Related product manuals