- 167 -
LP Engine G430(3.0L) Base Engine Service Procedure
8. Install the connecting rod cap and nuts.
Tighten
Tighten the nuts evenly to 61 N•m (45 lb•ft).
9. When all of the connecting rod bearings are
installed, tap each connecting rod assembly lightly
parallel to the crankpin in order to make sure that
they have clearance.
10. Use a feeler gauge or a dial indicator in order to
measure the side clearance between the
connecting rod caps. Refer to Engine Mechanical
Specifications.
Timing Gear Oil Nozzle Installation
1. Drive the new nozzle in place (oil hole facing up)
with a suitable light plastic or rubber hammer.
Crankshaft Sprocket Installation
Tools Required
• J 5590 Crankshaft Sprocket Installer
1. Install the keys into the crankshaft keyways.
2. Use the J 5590 in order to install the crankshaft
sprocket.
VE0107-3L
VE127-3L
VE106-3L
VE037-3L
To Next Page
Loading...
Need help?
General
