- 23 -
LP Engine G430(3.0L) Maintenance
specified coolant as required.
2. Periodically remove the pressure cap from the filler
neck to ensure the coolant recovery system is
functioning properly. Coolant must be at the top of
the filler neck. If coolant is low, check gasket in cap
for damage. Replace if mecessary. Inspect coolant
recovery system for leaks.
Inspect coolant hoses
●
Visually inspect coolant hoses and clamps.
●
Replace any hose that shows signs of swelling,
cracking, abrasion hardening or any other
damage/deterioration.
●
Top-up cooling system with approved coolant.
Inspect ignition system
●
Remove and inspect spark plugs.
Replace as required.
●
Test secondary wires with an Ohmmeter. Maximum
resistance repair replace as required.
●
Remove distributor cap and perform visual
inspection of distrbutor cap and rotor. Replace cap &
rotor if corrosion is found on contacts.
●
Inspect distributor breaker unit and housing for signs
of corrosion. Repair replace as required.
Replace spark plugs
●
Utilizing a gentle twisting motion remove the
secondary high voltage leads from the spark plugs.
Replace any damaged leads.
●
Remove the spark plugs.
●
Gap new spark plugs to proper specs.
●
Apply anti-seize compound to spark plug threads.
●
Install spark plugs.
●
Do not over tighten.
●
Install secondary high voltage leads.
Replace LP Fuel Filter Element
Park the lift truck in an authorized refueling area with
the forks lowered, parking beake applled and the
transmission in NEUTRAL.
1. Close the fuel shutoff valve on the LP-Gas tank.
Run the engine until fuel in the line runs out and the
engine stops. Turn off the ignition switch and
disconnect switch (if equipped).
2. Scribe a line across the filter housing covers.
3.Remove the cover retaining screws.
To Next Page
Loading...
Need help?
General
