INSTALLING HARDWARE 23
After power on, the network administrator should perform Network Setup, verify the network
connection, verify that the E-43A appears in the list of digital presses, and then print a few
test documents from a networked computer that will use the E-43A. For more information,
see Configuration and Setup, which is part of the user documentation set.
NOTE: The straight-through network cable at the customer site and the crossover Ethernet
cable included with the E-43A look similar, but are not interchangeable. Make sure that you
connect the network cable to the upper RJ-45 port on the E-43A connector panel (see
page 38).
Configuring a static IP address for the E-43A
If the customer requires the E-43A to be configured with a static IP address (for example, in a
non-DHCP network environment), obtain a valid static IP address from the network
administrator and configure the E-43A.
TO CONFIGURE A STATIC IP ADDRESS FOR THE E-43A
1 Press Home button on the copier/printer operational panel.
2 From the Home screen of the copier/printer touch panel, select Fiery. If the Fiery icon does
not display, press the button on the upper right corner of the screen to switch to the icon
view.
3 Press the Fiery tab.
4Press Setup.
5 On the Login screen, press Password. Enter Fiery.1. Press OK.
Ty pe Fiery.1 exactly as shown. The password is case-sensitive; for example, fiery.1 will not
work.
6 On the Setup screen, do the following:
• Press WINS. If enabled (yellow), press Use WINS to disable this feature. Press Save.
• Press DNS. If enabled (yellow), press Get DNS address automatically to disable this
feature. Press Save.
• Press IP Address. Enter an IP address. Press Save.
• Press IPv4 Address. Press Manual Configuration.
7 On the Manual Configuration screen, do the following:
• In the IP Address field, enter an IPv4 address. Press OK.
• In the Subnet Mask field, enter a subnet mask IP address. Press OK.
• In the Default gateway field, enter a default gateway IP address. Press OK.
• When done, press Save. Press Go Back.
8 On the Setup screen, press Exit Setup.
9 Press Reboot Now.
To Next Page
Loading...
Need help?
General
