EasyManuals Logo
Home>EFI>Controller>E-43A

EFI E-43A User Manual

EFI E-43A
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
REPLACING PARTS 63
Reinstall the battery.
Reassemble the E-43A (see page 86).
Reset the time and date in Setup (see Command WorkStation Help for more
information).
Verifying new motherboard installation, and transferring options and
BIOS information
After you install a new motherboard and reassemble the system, do the following:
Verify all functionality by using the motherboard replacement dongle to enter Service
Mode. (Service Mode is not indicated on the monitor or LCD, but is entered once you
power on with a new motherboard installed and the motherboard replacement dongle
installed on a USB port.)
Service Mode is a temporary state that allows you to make sure that the motherboard
solves the problem that you are troubleshooting. Service Mode is exited automatically
when you expend the motherboard replacement dongle to transfer options to the new
motherboard (see “Entering Service Mode” on page 64).
NOTE: Features of Fiery Impose-Compose are not available while in Service Mode.
If the new motherboard solves the problem that you are troubleshooting, use the
motherboard replacement dongle to transfer options to the new motherboard.
If you determine while in Service Mode that the problem you are troubleshooting was not
fixed by installing a new motherboard, do not expend the motherboard replacement
dongle to transfer options to the new motherboard (described below), do not install system
software, and do not replace the hard disk drive. Reinstall the old motherboard and return
the new motherboard and the unused motherboard replacement dongle to inventory. You
may then perform additional service and troubleshooting procedures.
Transferring options (for example, Fiery Graphic Arts, Premium Edition, if applicable)
expends the motherboard replacement dongle. For details, see “Entering Service Mode” on
page 64.
Do not transfer options to the new motherboard prematurely. Do so only after you verify the
new motherboard in Service Mode. Remember that once options are transferred to the new
motherboard using the motherboard replacement dongle, the motherboard is customized and
cannot be used in another system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EFI E-43A and is the answer not in the manual?

EFI E-43A Specifications

General IconGeneral
BrandEFI
ModelE-43A
CategoryController
LanguageEnglish

Related product manuals