USING THE E-43A 31
Printable Info menu
This section describes how to print pages such as the Test Page and Configuration page from
the Printable Info menu (described on page 30). The Printable Info menu is accessed through
the Fiery tab (see page 30).
Printing the Configuration page can be helpful during installation, Setup, and service. After
installing the E-43A (including connecting to the network), and before default settings are
changed in Run Setup, you can obtain a record of the defaults by printing the Configuration
page.
Before you perform any service procedure, you should print the E-43A Configuration page, if
possible, so you are prepared to return the settings to their former configuration, if necessary.
Printing the Te s t Pag e indicates that the E-43A is functional and that the connection between
the E-43A and the copier/printer is working.
TO PRINT A PAGE FROM THE PRINTABLE INFO MENU
1 If it is not powered on already, power on the copier/printer and allow it to warm up.
2 If it is not powered on already, power on the E-43A using the power button on the front panel
and allow it to start up completely (approximately three minutes).
3 Make sure that Idle appears on the Fiery Main menu.
If Busy or Printing appears, the E-43A is processing and you must wait until Idle appears.
4 Touch the Fiery tab.
5 Touch Printable Info and then select the page that you want to print.
The E-43A sends the selected page(s) to the copier/printer.
Restart Fiery
Shut down all E-43A activity in the correct manner and then restart. The following options
are available from the submenu that appears:
Restart Fiery Service: Resets the server software but does not reboot the entire system.
Network access to the E-43A is temporarily interrupted and all currently processing jobs are
aborted and may be lost.
Restart System: Shuts down and then reboots the E-43A. Network access to the E-43A is
terminated and all currently processing jobs are aborted and may be lost.
Shut Down: Shuts down all E-43A activity properly.
To Next Page
Loading...
Need help?
General
