DVC6000f Series
March 2006
C-2
Process Systems DeltaVt System
Getting Started with DeltaVt Host Systems
Appropriate Device Descriptions (DDs) installed. For example, working with a device revision 2
digital valve controller requires DDs that support device revision 2 be installed. For DD installation
information see Appendix B.
Digital valve controller correctly mounted on actuator. For mounting information see the
Installation section of this manual and the instructions included with the mounting kit.
Utilities connected. For information on making pneumatic and electrical connections, see the
Installation section of this manual. For information on applying power to the segment, see DeltaV
books online.
Instrument in standby. For information on placing the instrument in standby, see DeltaV books
online.
Perform the initial setup. See the Basic Setup and Tuning section of this manual. If the valve is
shipped from the factory mounted on an actuator, perform basic setup only to verify setup is
correct and valve operation is satisfactory.
Device Commissioned. For information on commissioning a device, see DeltaV books online.
Additional configuration required, such as setting alarms, cutoffs, and other resource block and
transducer block parameters. See the Detailed Setup section of this manual.
Control strategy defined. For information on defining a control strategy, see DeltaV books online.
Associate I/O with device. See DeltaV books online.
Download device. See DeltaV books online.
C
To Next Page
Loading...
Need help?
General
